Select a setup mode Express or Custom and continue. If you created a RAID volume on your boot disk as part of your prerequisite preparations for installing Windows, press C to select Custom Setup and manually partition the disk. Note – The complete Microsoft Windows operating system installation process is not documented in this section. Windows Setup lists the driver to be installed. Make sure to reserve a minimum of MB of unpartitioned space at the end of the drive. You will need to restart the system and go back to Step 3.
||7 August 2013
||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
||Free* [*Free Regsitration Required]
After pressing F6, a screen will appear providing you with the option to specify additional mass storage devices.
IBM Support: Fix Central – Please wait, Select fixes
If you do not eindows F6 while the prompt is being displayed, the screen allowing you to specify additional drivers is not displayed and the installation will fail.
When this message appears you will need to adwptec one of the following steps, depending on which driver delivery method you have chosen, to complete the installation:. Select the appropriate mass storage controller driver version depending on the version of Windows bit or bit you are installing, and then press Enter:. Remove disks or other media. Note – The prompt is displayed in the early stages of Windows Setup and lasts for approximately five seconds and is easy to miss.
If prompted with Press any devic to boot from CDquickly press any key. To Install the Operating System. Otherwise, press Enter to select Express Setup.
Supported_RAID-Controllers – smartmontools
At the Welcome to Setup screen, press Enter to continue. Install Windows Server Note – The complete Microsoft Windows operating system installation process is not documented in this section. Make sure that the mass storage drivers are accessible according to the mass storage driver installation method that you have selected. devics
Select a setup mode Express or Custom and continue. Connect the floppy drive to the JavaRConsole system if necessary and insert the mass-storage drivers floppy disk into the floppy drive.
This section documents only the steps that are specific for installing Windows Server on your server. Make sure to reserve a minimum of MB of unpartitioned space at the end of the drive.
You will need to restart the system and go back to Step 3. A screen appears listing the available drivers.
Windows Setup will then display your selection. Note that if you are using the floppy disk local installation method, the JavaRConsole floppy drive or floppy image devices must not be redirected. If you created a RAID volume on your boot disk as part of your prerequisite preparations for installing Windows, press C to select Custom Setup and manually partition the disk. This chapter describes how to install the Windows Server operating system directly onto your server using the Windows Server media.
Make sure that you have completed all of the requirements listed in Installation Requirements. The Windows installation will format the boot disk and all data will be lost. For requirements specific to the mass storage driver and Windows media delivery methods that you have chosen, see TABLE Follow these steps to install the Microsoft Windows Server software onto your your server.
Follow the on-screen instructions to complete the initial setup of Windows Server until you are prompted with the following message:. Ensure that the floppy. Then, press any key to restart the system and complete the Windows Server Installation. Press any key to restart. Before beginning the operating system installation, make sure that the following requirements are met. Windows Setup lists the driver to be installed.
Press S to specify additional devices. Press Enter to continue.
Press F6 when you see the following prompt at the bottom of the screen during the Windows Setup process: